Suzuki SY413 Service Manual page 2551

9J-82 AIR BAG SYSTEM
1. Trim cover must face up
2. 185 cm (6 feet) of clearance
1. Trim cover must face up
2. 185 cm (6 feet) of clearance
3. Mounting attachment
4. Bag opening side
7) In case of Driver Air Bag (Inflator) Module
a) Clear a space on the ground about 185 cm (6 feet) in diame-
ter where the driver air bag (inflator) module is to be
deployed. A paved, outdoor location where there is no activ-
ity is preferred. If an outdoor location is not available, a space
on the shop floor where there is no activity and sufficient ven-
tilation is recommended.
Ensure no loose or flammable objects are within the deploy-
ment area.
b) Place the driver air bag (inflator) module, with its vinyl trim
cover facing up, on the ground in the space just cleared.
7) In case of Passenger Air Bag (Inflator) Module
a) Clear a space on the ground approximately 185 cm (6 feet)
in diameter where the fixture (special tool) with attached air
bag (inflator) module is to be placed for deployment. A paved
outdoor location where there is no activity is preferred. If an
outdoor location is not available, a space on the shop floor
where there is no activity and sufficient ventilation is recom-
mended. Ensure that no loose or flammable objects are with-
in the deployment area.
b) Place special tool (passenger air bag (inflator) module de-
ployment fixture) on the ground in the space cleared in Step
a), if it has not already been placed there.
Special Tool
(Passenger air bag (inflator) module deployment fix-
ture)
(B): 09932-75040
c) Fill plastic reservoir in fixture (special tool) with water or
sand. This is necessary to provide sufficient stabilization of
the fixture during deployment.
d) Attach the passenger air bag (inflator) module in the fixture
(special tool) using mounting attachment and hold-down
bolts and nuts.
Air bag (inflator) module must be mounted such that the bag
will deploy upward. Securely hand-tighten all fasteners prior
to deployment.