Suzuki SY413 Service Manual page 2384

WINDSHIELD
The windshield is installed by using a special type of adhesive (that
is, one component urethane adhesive used with primer). For wind-
shield glass replacement, it is important to use an adhesive which
provides sufficient adhesion strength and to follow the proper pro-
cedure.
CAUTION:
Described here is the glass replacement by using one
component urethane adhesive to be used with primer
in combination. Each adhesive has its own drying and
setting time and must be handled and used in a certain
specific procedure. Negligence in following such pro-
cedure or misuse of the adhesive in any way hinders
its inherent adhesive property. Therefore, before the
work, make sure to read carefully the instruction and
description given by the maker of the adhesive to be
used and be sure to follow the procedure and observe
each precaution throughout the work.
Should coated surface be scratched or otherwise
damaged, be sure to repair damaged part, or corrosion
may start from there.
Use an adhesive of above mentioned type which has the following
property.
Shearing strength: 40 kg/cm
BODY SERVICE 9-15
1. Upper molding
2. Glass spacer
3. Glass stopper
4. Windshield
2 2
(569 Ib/in ) or more