Suzuki SY413 Service Manual page 2392

[A] [B]
1. Adhesive
2. Primer coated surface
3. Clip
[A] [B]
1. New brush
2. Primer for body
[A]
[B]
1. New brush
2. Primer for glass
3. Molding
4. Glass
8) When re-using glass, remove adhesive from glass, using care
not to damage primer coated surface.
[A]: Hatch-back model
[B]: Wagon model
INSTALLATION
1) Using cleaning solvent, clean window opening edge where win-
dow glass is to be adhered. (Let it dry for more than 10 minutes.)
2) Using a new brush, apply sufficient amount of primer for body
along body surface where window is to be adhered.
NOTE:
Be sure to refer to maker's instruction for proper handling
and drying time.
[A]: Hatch-back model
[B]: Wagon model
3) Clean glass surface to be adhered to window with clean cloth.
If unleaded gasoline is used, let it dry for more than 10 minutes.
4) Attach glass into new molding. (For hatch-back model)
5) Clean molding surface "A" with clean cloth.
Refer to figure on Step 7).
6) Using a new brush, apply sufficient amount of primer for glass
along glass surface to be adhered to window.
NOTE:
Width "a": Approximately 18 mm (0.7 in.)
[A]: Hatch-back model
[B]: Wagon model
Be sure to refer to maker's instruction for proper han-
dling and drying time.
Do not touch primer coated surface.
"b": Approximately 16 mm (0.63 in.)
"c": Approximately 7 mm (0.28 in.)
BODY SERVICE 9-23