Suzuki SY413 Service Manual page 2223

1. Release bearing
2. Release shaft arm
3. Input shaft
6) Hook return spring.
7) Apply grease to release bearing inside and release shaft arm,
then set bearing.
"A": SUZUKI SUPER GREASE A, 99000-25010
8) Apply small amount of grease to input shaft spline and front
end as well.
"B": SUZUKI SUPER GREASE I, 99000-25210
9) Set release arm to release shaft aligning their punch marks,
then tighten bolt.
Tightening Torque
(a): 23 N·m (2.3 kg-m, 17.0 lb-ft)
1. Release arm bolt
A: Align punch marks
10) If clutch cable bracket has been removed or replaced, install
it with 2 bolts.
Tightening Torque
(b): 23 N·m (2.3 kg-m, 17.0 lb-ft)
1. Cable bracket bolt
CLUTCH (CABLE TYPE) 7C-11