Programming Zwave Devices; Zwave Room Names; Add A Zwave Device - Interlogix ZeroWire ZW-6400 Reference Manual

4.10 Programming Zwave Devices

Press then for the page.
See the Zwave Configuration Menu later in this section.
Also reference Devices Programming (Advanced), section 5.9.

Zwave Room Names

Select Zwave Room Names from the drop down menu.
From the drop down menu under Zwave Room Editor select a room to edit the name.
For this example we will change the name of Room 1 to Living Room.
Type Living Room in the form "Edit Room Name:"
Press Save. The notification box will alert you that the Room Name is Saved. The drop down
list has been updated for Room 1.

Add a Zwave Device

Select Zwave Add/Remove from the drop down menu.
1. Press Add.
2. Initiate ADD mode on ZWave device. See your ZWave device's manual for instructions.
The notification box will alert you that the Device is added.
Note: If a ZWave device has been added before or to another system, you must first remove
it before adding it to this system. To do this, press Remove, then activate LINK or REMOVE
mode on the device.
C I
... ... 62 .. ...
ZeroWire Reference Guide
P/N 466-5227 • REVA • ISS 26AUG15
©2015 United Technologies Corporation
.. . ..