Option 1 - Ethernet Setup - Interlogix ZeroWire ZW-6400 Reference Manual

2.2 Option 1 - Ethernet Setup

To internet
Router
Connect power to your ZeroWire.
If this ZeroWire was previously connected via Wi Fi, switch connection to Ethernet:
Connect an Ethernet cable to the rear of the ZeroWire and wait 10 sec for the local router to
assign the ZeroWire an IP address.
On the ZeroWire press Menu – 8 – [PIN] – 6 and note the IP address announced. This is the
IP address of your ZeroWire. If you hear "IP address is not configured" then wait a further 30s
and repeat this step.
Open your web browser.
Enter IP address. The ZeroWire login screen should appear:
Enter your username and password. By default this is: installer and 9-7-1-3.
You should now see a screen similar to one of the below:
Your ZeroWire is now successfully connected to your Ethernet network.
Press Settings or Advanced to program your ZeroWire.
C I
... ... 20 .. ...
ZeroWire Reference Guide
P/N 466-5227 • REVA • ISS 26AUG15
©2015 United Technologies Corporation
.. . ..