Interlogix ZeroWire ZW-6400 Reference Manual page 39

Option
Select Sensor to Configure
Sensor Name
Sensor Type
Sensor Option
Area Group
Serial Number
Tamper
Disable Internal Reed
Norm Open External Contact
Voice Name 1
Voice Name 2
Voice Name 3
Voice Name 4
When you are finished programming the Sensor,
Press the Save button.
A dialogue box appears.
Press the OK button.
A dialogue box appears.
Press the OK button.
These dialogue boxes appear after any changes to the system are attempted/registered.
C
... ... 39
P/N 466-5227 • REVA • ISS 26AUG15
Default
1 Sensor
Blank
3 Entry Exit Delay 1
1 Bypass
1 Area 1
Blank
On
Off
Off
Blank
Blank
Blank
Blank
ZeroWire Reference Guide
Function
Choose among 60 sensors.
Custom 32 character name
Sensor types determine the sensor
attributes such as entry/exit, instant, etc.
Additionally sensor types determine the
siren attributes.
Sensor options determine the sensor
attributes such as a sensor's ability to be
bypassed, force arm, Cross Zone, stay
mode, etc. Additionally sensor options
determine the sensors reporting attributes.
Assigning a sensor to an area will enable it
to report.
This is the TXID of the wireless sensor, it
can be manual entered or the sensor can be
"Learned" into panel.
Tamper switch on the wireless sensor is
enabled or disabled.
The internal reed switch(es) on the wireless
device can be disabled.
The external input on wireless sensors can
be enabled. If the 60-362N-10-319.5 sensor
is used the jumper PIN does not have to be
used.
This feature uses the internal voice
vocabulary to name the sensor. These
names will be announced in sequence when
the sensor is opened while in the Chime
mode.
©2015 United Technologies Corporation
I
.. ...
.. . ..