Interlogix ZeroWire ZW-6400 Reference Manual page 159

External Antenna Connector.
Use ONLY with external antenna
Connect an external antenna to the antenna connector on the rear of the ZeroWire. To obtain
maximum signal strength the external antenna must be fully extended. Re-check signal
strength following steps in section 7.3.
Move the ZeroWire or the antenna to another location if the signal is still too low.
Place the external antenna to optimize signal strength.
Note: The external antenna can be used wherever the panel is installed. The antenna can be
mounted in a wall for that kind of installation, or extended from the panel in a table mount
installation.
C
... ... 159
P/N 466-5227 • REVA • ISS 26AUG15
ZeroWire Reference Guide
©2015 United Technologies Corporation
I
.. ...
.. . ..