Interlogix ZeroWire ZW-6400 Reference Manual page 161

If it does not:
Check cellular connection:
a. Look at cell state, it should display Connected.
b. Wait until cell state displays Connected, press Reload to refresh the status.
c. Check signal strength – signal strength should be between -91 to -51.
d. Contact Tech Support for assistance.
e. Check that radio is correctly installed and firmly connected to the 10 pin cable.
f. Check if antenna is correctly installed or move antenna to a higher location.
If you need to make changes, open the ZeroWire Web Server and go to Advanced –
Communicator – Radio Configuration:
Only change these settings as instructed by your supplier or telecommunications provider.
C
... ... 161
P/N 466-5227 • REVA • ISS 26AUG15
Connected
Valid service
-76
ZeroWire Reference Guide
©2015 United Technologies Corporation
I
.. ...
.. . ..