Add Camera To Network Via Ethernet For Windows Pc (Non Dhcp); Add Camera To Network Via Ethernet (Dhcp) - Interlogix ZeroWire ZW-6400 Reference Manual

8.7 Add Camera to Network via Ethernet for Windows PC (non
DHCP)
1. Power up the camera. (Boot up may take 1-2 minutes)
2. From your Windows PC, Find and connect to TVW-xxxxx in Wi Fi network list.
3. Go to Network and Sharing Center.
Control Panel > Network and Internet > Network and Sharing Center
4. Click Change Adapter Settings on left.
5. Right click Wireless Network Connection and select Properties.
6. Click Internet Protocol Version 4 (TCP/IPv4) and click Properties.
7. Click "Use the following IP address", enter the info below, and then click OK.
a) IP address:
b) Subnet mask:
8. Open Browser (Firefox, Chrome, IE8) and enter the camera's IP Address into the
browser's address bar.
Camera's Default IP Address is 192.168.1.70.
a)
9. TruVision Configurator will appear. Enter Credentials below.
a) User Name:
b) Password:
10. Click Configuration on the top menu.
11. Click Network on the left menu.
12. Change LAN settings to desired configuration.
a) Change the IPv4 Address and IPv4 Subnet Mask to match the router if a static
IP Address is desired.
i. You must change the static IP address to something different than the default 192.168.1.70 if
more than one camera is used on the network.
ii. Make sure to use the Test button to validate IP Address is not already assigned to another
device in the network.
13. Click Save on the bottom of the screen.
You are now connected to the network via Wi Fi!

8.8 Add Camera to Network via Ethernet (DHCP)

1. Power up the camera. (Boot up may take 1-2 minutes)
2. Connect router and camera with Ethernet cable.
You are now connected to the network via Wi Fi!
C
... ... 167
P/N 466-5227 • REVA • ISS 26AUG15
192.168.1.71
255.255.255.0
admin
1234
ZeroWire Reference Guide
©2015 United Technologies Corporation
I
.. ...
.. . ..