Interlogix ZeroWire ZW-6400 Reference Manual page 101

1. First Disarm Last Arm
If enabled, the ZeroWire will only send a closing report when the last area is armed.
Note: The last area to arm must have open/close reports enabled. The ZeroWire will only send an
opening report when the first area is disarmed.
This feature is used in place of Individual area Open and close. If you enable open and close in the area
you will get both individual open and close and System open close
2. Report Once Per Sensor
If enabled, this will limit reporting to only once per sensor each time you arm or disarm a area. This stops
the control room or reporting destination to be flooded by multiple reports that the same sensor is being
activated (for example the intruder may be moving around and is being picked up by the sensor on that
sensor).
3. Suppress Force Arm Bypass
If enabled, the ZeroWire does not send bypass reports when a sensor is forced armed.
If not enabled, when a sensor is forced armed and it remains in a state of creating an alarm, bypass
reports are sent at the end of exit time. For example this would occur if it remains unsealed at the end of
the exit time, or due to change of sensor type caused by a schedule.
If forced armed sensors re-seal during the armed period, bypass restores are sent.
4. Immediate Restore
If enabled, the ZeroWire will immediately send all restorals as the sensor reports the event.
If not enabled, the ZeroWire will send restoral events all at the same time when the marea is disarmed.
2 Auto Test/Intervals
Set day of the week to send an automatic test
report to the system channel group .
(Communicator\System Event Reporting\System
Channels). You may also set auto-test to Daily.
C
... ... 101
P/N 466-5227 • REVA • ISS 26AUG15
3 Auto Test/Time
Enter the time at which the automatic test report
should be sent. This should be in 24-hour format. For
example 18:00.
ZeroWire Reference Guide
©2015 United Technologies Corporation
I
.. ...
.. . ..