View Event Triggered Clips In History; Remove Camera From Ultrasync (If Needed); Change Default Camera Settings (Via Truvision Navigator) - Interlogix ZeroWire ZW-6400 Reference Manual

8.12 View event triggered clips in History

Press on bottom of the screen.
Press
Find the Event you wish to view using Oldest, Prev, Next, and Latest buttons.
Once you find the clip you wish to view, press Play Video Clip.

Remove Camera from UltraSync (if needed)

1. Press the More tab on the bottom of the Screen.
2. Press Settings.
3. Select Cameras under Settings Selector.
4. Select the camera you with to remove.
5. Delete text in Camera Name, IP Address and MAC Address.
6. Press Save.
Remove All Cameras Shortcut: To remove all cameras from UltraSync, go to Advanced
Settings and use SHORTCUT 910.22.
Reset Camera to Factory Default (if needed)
If needed, the camera can be reset to factory default. Remove the camera cover, then press
and hold the RST/WPS button for 20 Seconds.

8.13 Change Default Camera Settings (Via TruVision Navigator)

1. From a computer or mobile device that is connected on the same network as the camera,
type in the IP address of the camera into the devices browser.
2. Login using default login.
a. Login: admin
b. Password: 1234
3. Change settings as desired such as video quality, frame rate, pre and post recording times.
4. For detailed instructions on using TruVision Navigator, go to www.interlogix.com/video.
C
... ... 171
P/N 466-5227 • REVA • ISS 26AUG15
ZeroWire Reference Guide
©2015 United Technologies Corporation
I
.. ...
.. . ..