Add Camera To Ultrasync - Interlogix ZeroWire ZW-6400 Reference Manual

8.9 Add Camera to UltraSync

Ensure proper installation of camera hardware before proceeding to camera setup.
Make sure camera and UltraSecure intrusion panel are on the same local area network.
Applications were the Intrusion panels uses cellular only are not compatible with this camera.
Note: For detailed information on how to setup the UltraSync app, add locations, and login
as an Installer, reference the intrusion panel installation guide.
Press then for the page.
Select Cameras from the drop down menu.
Press Scan for New Cameras. "Success!" message will pop-up after a few moments.
The scan results in an IP address and MAC address listing in the form fields shown.
Make sure the MAC ID that is automatically populated in the MAC Address field matches the
MAC Address printed on the back of the camera. If not, change in the MAC Address to the
one listed on the back of the Camera.
Press Save.
Note: Camera may take up to 1-2 minutes to finalize association with intrusion panel and
show in cameras tab.
CONGRATULATIONS! You have now added the camera to UltraSync!
C I
... ... 168 .. ...
ZeroWire Reference Guide
P/N 466-5227 • REVA • ISS 26AUG15
©2015 United Technologies Corporation
.. . ..