Add Camera To Network Via Ethernet For Ios Device (Non Dhcp) - Interlogix ZeroWire ZW-6400 Reference Manual

8.6 Add Camera to Network via Ethernet for iOS Device (non
DHCP)
1. Power up the camera. (Boot up may take 1-2 minutes)
2. From your iOS device, go to Settings, then Wi Fi.
3. Find and select TVW-xxxxx. (Listed under Devices)
4. Once connected, press the info circle on the right of TVW-xxxxx.
5. Under IP Address, press Static and enter the info below.
a) IP Address
b) Subnet Mask
6. Open Mobile Browser. (Safari)
7. Enter the camera's default IP Address into the address bar.
a) 192.168.1.70
8. TruVision Configurator will appear. Enter Credentials below.
a) User Name:
b) Password:
9. Press Configuration on the top menu.
10. Press Network on the left menu.
11. Change LAN settings to desired configuration.
a) Change the IPv4 Address and IPv4 Subnet Mask to match the router if a static
IP Address is desired.
i. You must change the static IP address to something different than the default 192.168.1.70 if
more than one camera is used on the network.
ii. Make sure to use the Test button to validate IP Address is not already assigned to another
device in the network.
12. Press Save on the bottom of the screen.
You are now connected to the network via Ethernet!
C
... ... 166
P/N 466-5227 • REVA • ISS 26AUG15
192.168.1.71
255.255.255.0
admin
1234
ZeroWire Reference Guide
©2015 United Technologies Corporation
I
.. ...
.. . ..