Interlogix ZeroWire ZW-6400 Reference Manual page 88

4 Area Options
1. Arm/Disarm Reports
If enabled, this area will send open and close reports via one or more appropriately configured channels.
2. Quick Away
If enabled, this area can be armed in away mode via a single away mode key press. When an area is
armed via quick away mode, the closing user number is the default user of 999.
3. Arm In Stay If No Exit
If enabled, Arm In Stay If No Exit will cause this area to arm in stay mode even when a user arms it in
away mode, providing that an entry 1 or entry 2 sensor type is not triggered during the exit delay.
This allows the ZeroWire to behave intelligently – arming in Away mode if a user leaves the building, and
arming in Stay mode if the user stays inside.
Stay mode encourages ZeroWire user to use their alarm system more frequently when the premise is
occupied. Designated stay sensors (e.g. located perimeter motion sensors and doors) will be active in stay
mode while all non-stay sensors (e.g. located upstairs) will be bypassed.
When armed in the stay mode, the opening of any sensors designated as stay mode sensor will initiate
the keypad sounder and start the stay entry delay before creating an alarm. All other sensors and non-fire
sensors will be bypassed during stay mode.
4. Quick Stay Mode Disarm
If enabled, this will allow the stay mode to be disarmed by pressing the stay key on the keypad. This is
only possible if the is no alarm active and the stay entry delay is currently running.
This is a convenience feature avoiding the need to enter the PIN to disarm from stay mode.
At the end of the stay entry delay or if there is an area alarm, the stay mode can only be disarmed via a
valid user PIN.
5. Siren Chirp Away
If enabled, the ZeroWire will activate the built-in siren briefly each time this area is set in away mode or
disarmed with a key-switch sensor or wireless keyfob.
C I
... ... 88 .. ...
ZeroWire Reference Guide
P/N 466-5227 • REVA • ISS 26AUG15
©2015 United Technologies Corporation
.. . ..