Install The Battery; Connect Power Lead To Panel; Install Zerowire Panel - Interlogix ZeroWire ZW-6400 Reference Manual

1.1 Install the Battery

Remove battery cover
with a small
screwdriver.

1.2 Connect Power Lead to panel

Connect power lead from power supply to the back of the ZeroWire. The connector is keyed
and only fits one way.

1.3 Install ZeroWire Panel

ZeroWire may be mounted on a wall (recommended) or on a table.
For table mount information please
Install the bracket on a wall by using the supplied screws. Make sure the power lead can
reach the ZeroWire when plugged in to a power source.
Note: Holes in the wall supplying Ethernet, power, antenna or I/O connector must be in the
shaded area to ensure the unit mounts flat on the wall; See the drawing on the next page.
C
... ... 16
P/N 466-5227 • REVA • ISS 26AUG15
Connect battery pack
lead to connector on the
left inside battery
compartment.
Connectors are keyed.
reference Section 9.21
ZeroWire Reference Guide
Replace battery cover
and screw.
©2015 United Technologies Corporation
I
.. ...
.. . ..