Programming Instructions For Event Lists - Interlogix xGenConnect NXG-4 Installation And Programming Manual

5. Enter the required details into your device/software. This will usual be your
xGenConnect serial number, Web Access Passcode, and a valid Username
and PIN code. The xGenConnect serial number can be found in the Device
Info menu.
6. Verify the UltraSync service is working by using your device/software to
connect your xGenConnect system.
Troubleshooting
•
Check the Web Access Passcode is correct. It cannot be 00000000.
•
Check there is a valid user and they have a First name, this will be the login
name.
•
Check the serial number is correct. It is printed on the xGenConnect module.
•
Check that the user permissions are currently valid.
See also "Appendix 2: App and Web Error Messages" on page 155.

Programming Instructions for Event Lists

Goal
Create segmented lists of events so Channels can selectively deliver event
messages.
Pre-conditions
None.
Notes
•
If an event message is enabled in an Event List, then the Channel will attempt
to deliver it. If an event message is not enabled on the Event List, the
Channel will not attempt delivery even if the message has been sent to it.
•
Event List set up for push notifications is automatically performed by the
UltraSync+ app when required. The panel will assign the next available
channel and matching event list number. No configuration via the web pages
or DLX900 is required.
Programming Sequence
17. Event Lists
xGenConnect Installation and Programming Guide
5. Channels
→
6. Communicator
17. Event Lists
135