Table of Contents
Advertisement
set autopartition
User level: privileged, supervisor.
This command is not relevant to P330-ML-ML switches. It appears in the P330-
ML-ML CLI for controlling autopartition of other P330-ML switches in the
stack.
Use the set autopartition command to enable or disable auto-partitioning on
P330-ML switches in the stack.
The syntax for this command is:
set autopartition <value>[module]
value
module
Example:
P330-N# set autopartition enable 3
Auto-partition is enabled in module 3.
set boot bank
User level: privileged, supervisor.
This command is not available on the P333R and P333R-LB.
Use the set boot bank command to configure the software bank from which the
switch will boot at the next boot process. This command should be issued separately
for each switch in the stack using the session command first.
If you wish to execute this command on a switch other than the stack master,
you must open a session the relevant switch.
The syntax for this command is:
set boot bank <value>
value
Example:
P330-N# set boot bank bank-a
Boot bank is set to bank-a
Avaya P330-ML Reference Guide
enable/disable
module slot number
{bank-a | bank-b}
Chapter 2
Avaya P330-ML Layer 2 CLI Commands
61
Advertisement
Table of Contents
