Table of Contents
Advertisement
Chapter 2
Avaya P330-ML Layer 2 CLI Commands
priority
Example:
Router-N# set port powerinline priority 2/3 HighLoad
Powering priority on port/s 2/3 was set to High
set port redundancy
User level: privileged, supervisor.
Use the set port redundancy command to globally enables or disable the port
redundancy pairs you have defined. Using this command will not delete from
NVRAM the existing redundancy entries.
The syntax for this command is:
set port redundancy {enable|disable}
Example:
P330-N# set port redundancy enable
All redundancy schemes are now enabled
set port redundancy on/off
User level: privileged, supervisor.
Use the set port redundancy command to defines or remove redundancy pairs. A
port redundancy member can be any port (including LAG logical port) that is not a
member of a LAG or another redundancy scheme.
The syntax for this command is:
set port redundancy <module>/<prim_port>
<module>/<second_port> {on/off} [<redundancy_name>]
prim_port
second_port
redundancy_name
(Optional)
98
Critical, High, or Low
Primary port of the redundancy scheme
Secondary port of the redundancy scheme
Name for the redundancy scheme
Avaya P330-ML Reference Guide
Advertisement
Table of Contents
