Router Configuration Contexts; Shortcuts To Commands By Context - Avaya P330-ML-ML Reference Manual

Chapter 3
Avaya P330-ML Layer 3 CLI Commands
This chapter provides all the Layer 3 CLI (Command Line Interface) commands,
parameters, and their default values.
How the Layer 3 CLI is Organized
The commands that make up the Layer 3 CLI are organized alphabetically and
according to context.

Router Configuration Contexts

You can either use the general Layer 3 commands available from the
Router(configure)# prompt or you can enter one of two router configuration
context modes:
Router interface context
Allows you to define parameters individually for each interface. To enter this
context, type interface <interface_name>
The prompt changes to Router-N(config-if:<interface_name>)#
Router protocol context
Allows you to define parameters for a specific routing protocol (RIP, OSPF, and
SRRP). To enter this context, type router <protocol_name>
The prompt changes to Router-N(config router:<protocol_name>)#
To exit these context modes, type the command exit.

Shortcuts to Commands by Context

Command descriptions are organized into the following contexts:
General Commands
Interface context Commands
Router RIP context Commands
Router OSPF context Commands
Router SRRP context Commands
Avaya P330-ML Reference Guide
Page 212
Page 274
Page 291
Page 293
Page 296
211