Table of Contents
Advertisement
The syntax for this command is:
set interface ppp <ip_addr> <net-mask>
ip_addr
net-mask
Example:
P330-N# set interface ppp 149.49.34.125 24
Interface ppp ip address set
set interface ppp enable/enable-always/disable/off/reset
User level: privileged, supervisor.
Use the set interface ppp command to enter modem mode, enter terminal
mode, disconnect the PPP session or to reset the connected modem.
The syntax for this command is:
set interface ppp {enable|enable-always|disable|off|reset}
enable
enable-always
disable
off
reset
Example:
P330-N# set interface ppp reset
PPP has reset the connected modem.
Avaya P330-ML Reference Guide
Chapter 2
IP address used by the P330-ML Supervisor Module to connect
via its PPP interface
Subnet mask used by the P330-ML Supervisor Module to
connect via its PPP interface
Enable PPP and enter modem mode.
Enter modem mode every time that the proprietary modem
cable is plugged into the console port.
Disable PPP and enter terminal mode
Disconnect the active PPP session.
Reset the connected modem.
Avaya P330-ML Layer 2 CLI Commands
69
Advertisement
Table of Contents
