Set Allowed Managers - Avaya P460 Reference Manual

The syntax for this command is:
session [[module_number>] {switch | router}]
module
switch|router
(Optional)
Example:
P460-1> session router
Router-1 (super) #
The security level stays the same when you use the session command.

set allowed managers

User level: read-write, admin.
Use the set allowed managers command to enables or disable the Allowed
Managers feature.
When this feature is enabled, only those stations whose IP addresses are listed in the
Allowed Managers table can access the device over Telnet, SNMP, or HTTP.
The syntax for this command is:
set allowed managers [enabled|disabled]
Example:
P460-1(super)# set allowed managers enabled
Managers are enabled
Avaya P460 Reference Guide
Chapter 2
The Supervisor module number (1...2).
• The entity to which you want to open a
session.
• If you do not specify this parameter, you
will get the default entity of the specific
module:
• switch - Layer 2 entity of the module.
• router - Routing entity
Avaya P460 CLI Commands
71