Crypto Key Generate Dsa - Avaya P330-ML-ML Reference Manual

Chapter 2 Avaya P330-ML Layer 2 CLI Commands
copy tftp SW_powerinline_image
User level: supervisor
This command applies to P333T-PWR switches only and is used by P330-
ML-ML switches to control P333T-PWR modules in the stack.
Use the copy tftp SW_powerinline_image command to update the inline
software application from a TFTP server to the memory of a designated module.
You need to be in privilege mode to execute this command.
The syntax for this command is:
copy tftp SW_powerinline_image <image-file> <ip-addr> <mod-
num>
image_file
ip_addr
mod_num
Example:
P330-ML-2# copy tftp SW_powerinline_image
c:\p333t\p333T_203
Module:
Source file:
Destination file:
Host:
Running state:
Failure Display:
Last warning:
Download completed
Before executing the download, the following checks will be performed by
embedded SW, on the TFTP server file:
— Ensure that the file size is within its allocated space.
— Check that the file contains embedded web SW for this application
— Verify file validity by calculating the checksum.

crypto key generate dsa

User level: supervisor
Use the crypto key generate command to create the host key.
32
Common name for the file that contain the Power
over Ethernet (PoE) Software image and the
Embedded Web archive (full path)
IP address of the TFTP host
Target module number
192.168.49.10
5
c:\p333t\p333t_203
Powerinline
192.168.49.10
Downloading
Access Violation
5
Avaya P330-ML Reference Guide