This command can only be run from the console port on the device.
The syntax for this command is:
set terminal recovery password enable
Example:
P330-N# set terminal recovery password enable
Done!
set time client
User level: privileged, supervisor.
Use the set time client command to enable or disable the periodic network
time acquisition by the switch from the network time server (SNTP or TIME
protocol).
The syntax for this command is:
set time client {enable|disable}
enable
disable
Example:
P330-N# set time client enable
Time client mode enabled
set time protocol
User level: privileged, supervisor.
Use the set time protocol command to set the protocol for use in the system as
either SNTP protocol or TIME protocol.
The syntax for this command is:
set time protocol
sntp-protocol
time-protocol
Avaya P330-ML Reference Guide
Chapter 2
Enable periodic network time acquisition
Disable periodic network time acquisition
[sntp-protocol|time-protocol]
Use the SNTP protocol
Use the TIME protocol
Avaya P330-ML Layer 2 CLI Commands
123