Show Autopartition - Avaya P333R User Manual

Chapter 5 CLI – Layer 2

show autopartition

Use the show autopartition command to display the automatic partition.
Note: Autopartition for the P330-ML switches will always have the value
disabled. This command is used to display the autopartition status for the other
P330 switches in the stack.
The syntax for this command is:
show autopartition [module]
Example:
P330-N> show autopartition 1
Mod
--- -----------
1 Enable
show dev log file
Use the show dev log file command to display the encrypted device's log file.
Note: This command is only supported by the P330-ML switches.
The syntax for this command is:
show dev log file
show log
Use the show log command to display an encrypted device's reset log. This
command is for Avaya technical support use.
The syntax for this command is:
show log [module]
Output Example:
P330-1(super)# show log 1
MODULE 1, MESSAGE 01:
00000000 0 05002966 0205 0 0 0 0 0 0 0 0 0 0
MODULE 1, MESSAGE 02:
64
Mode
Avaya P333T-PWR User's Guide