Set Trunk; Set Utilization Cpu - Avaya P330-ML-ML Reference Manual

set trunk

User level: privileged, supervisor.
Use the set trunk command to configure the VLAN tagging mode of a port.
set trunk <module/port> {off|dot1q}
module
port
off
dot1q
Example:
P330-ML-1#
Dot1Q VLAN tagging set on port 3/3.

set utilization cpu

User level: privileged, supervisor.
Use the set utilization cpu command to enable CPU utilization monitoring
on the specified module.
The syntax for this command is:
set utilization cpu <module-number>
module-
number
Example:
P330-N# set utilization cpu 1
CPU utilization is set on module 1
Done!
Avaya P330-ML Reference Guide
Chapter 2
Number of the switch.
Number of the port on the switch.
You can also specify a range of ports separated by a dash,
for example, 4/5-13 for ports 5 to 13 on switch 4.
Forces the port to become a non-tagging port.
Specifies an IEEE 802.1Q tagging on a Fast Ethernet or
Gigabit Ethernet port.
set trunk 3/3 dot1q
The module number for which CPU utilization monitoring is
enabled.
Avaya P330-ML Layer 2 CLI Commands
125