Set Port Auto-Negotiation-Flowcontrol-Advertisement; Set Trunk - Avaya P333T User Manual

Chapter 6 CLI – Layer 2

set port auto-negotiation-flowcontrol-advertisement

The set port auto-negotiation-flowcontrol-advertisement command
sets the flowcontrol advertisement for a Gigabit port when performing
autonegotiation.
The syntax for this command is:
set port auto-negotiation-flowcontrol-advertisement <mod_num>/
<port_num> {no-flowcontrol|asym-tx-only|sym-only|sym-and-asym-rx}
no-flowcontrol
asym-tx-only
sym-only
sym-and-asym-rx
Output Example:
P330-N#
1/5 asym-tx-only
P330-N# Port 1/5 pause capabilities was set

set trunk

Use the set trunk command to configure the tagging mode of a post.
set trunk [module/port] [value]
module/port
value
Output Example:
P330-1(super)# set trunk 2/20 dot1q
Dot1Q VLAN tagging set on port 2/20.
114
The port will advertise no pause capabilities.
The port will advertise asymmetric Tx pause capabilities only.
The port will advertise symmetric pause capabilities only.
The port will advertise both symmetric and asymmetric Rx
pause capabilities.
set port auto-negotiation-flowcontrol-advertisement
module/port number
off/dot1q
Avaya P333T User's Guide