set port autonegotiation-flowcontrol-advertisement
The set port autonegotiation-flowcontrol-advertisement command
sets the flowcontrol advertisement for a Gigabit port when performing
autonegotiation.
Note: Using the set port autonegotiation-flowcontrol-advertisement is
not supported on 10/100BaseT ports .
The syntax for this command is:
set port autonegotiation-flowcontrol-advertisement <mod_num>/
<port_num> {no-flowcontrol|asym-tx-only|sym-only|sym-and-asym-rx}
no-flowcontrol
asym-tx-only
sym-only
sym-and-asym-rx
Output Example:
P330-N#
5 asym-tx-only
P330-N# Port 1/5 pause capabilities was set
set trunk
Use the set trunk command to configure the tagging mode of a post.
set trunk [module/port] [value]
module/port
value
Output Example:
P330-1(super)# set trunk 2/20 dot1q
Dot1Q VLAN tagging set on port 2/20.
Avaya P334T-ML User's Guidee
The port will advertise no pause capabilities.
The port will advertise asymmetric Tx pause capabilities only.
The port will advertise symmetric pause capabilities only.
The port will advertise both symmetric and asymmetric Rx
pause capabilities.
set port autonegotiation-flowcontrol-advertisement 1/
module/port number
off/dot1q
Chapter 6
CLI – Layer 2
125