Adjusting The Basic Position Of The Hand Brake Lever; Checking The Rear Brake Linings - KTM 1190 RC8 R EU/UK 2009 Repair Manual
Hide thumbs
Also See for 1190 RC8 R EU/UK 2009:
- Owner's manual (283 pages) ,
- Owner's manual (281 pages) ,
- Owner's manual (242 pages)
Table of Contents
Advertisement
13/BRAKE SYSTEM
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
Never user DOT 5 brake fluid! It is silicone-based and purple in color. Oil seals and brake lines are not designed for DOT 5
brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid is corrosive and will damage painted surfaces.
Use only clean brake fluid from a sealed container!
Adjusting the basic position of the hand brake lever
16.6
Checking the rear brake linings
16.7
Warning
Danger of accidents Reduced braking efficiency caused by worn brake linings.
–
Change worn brake linings immediately.
Note
Danger of accidents Reduced braking efficiency caused by damaged brake discs.
–
If the brake linings are not changed in time, the steel brake lining carriers grind on the brake disc. The braking effect is greatly
reduced and the brake discs are rendered unserviceable. Check the brake linings regularly.
–
Move the brake fluid reservoir mounted on the handlebar to a horizontal position.
–
Loosen screw.
–
Remove cover
–
Add brake fluid to the MAX level.
Brake fluid DOT 4 / DOT 5.1 (
–
Position the cover with the membrane. Mount and tighten the screws.
Info
100714-10
Clean up overflowed or spilt brake fluid immediately with water.
–
Pull the brake lever forwards.
–
Adjust the basic setting of the hand brake lever to your hand size by turning adjust-
ing wheel
Info
Do not make any adjustments while riding!
100711-10
–
Check the brake linings for minimum thickness
Minimum thickness
»
If the minimum thickness is less than specified:
–
Change the rear brake linings. (
–
Check the brake linings for damage and cracking.
»
If damage or wear is encountered:
–
Change the rear brake linings. (
100718-10
with membrane
.
p. 436)
.
.
≥ 1 mm (≥ 0.04 in)
p. 97)
p. 97)
96
Advertisement
Table of Contents
