02/HANDLEBAR, CONTROLS AND INSTRUMENTS
Adjusting the play in the throttle cable
6.4
–
Tighten the screw.
Guideline
Screw, handlebar stub
–
Repeat the adjustments on the other handlebar stub.
–
Move the handlebar to and fro over the entire steering range.
»
If the cables restrict the freedom of movement of the steering:
–
Correct the cable routing.
100759-01
Adjusting the low position of the handlebar stubs:
–
Loosen screw
Info
Loosen the screw several turns to prevent damage to the fork lacquer
when moving the handlebar stub.
100759-10
–
Remove screw
–
Carefully shift the handlebar stub by the length of the distance sleeve.
Guideline
Long distance sleeve
–
Lay all cables between the upper triple clamp and the handlebar stub.
–
Position the distance sleeves.
–
Mount and tighten the screw.
Guideline
100760-10
Remaining frame bolts
–
Tighten the screw.
Guideline
Screw, handlebar stub
–
Repeat the adjustments on the other handlebar stub.
–
Move the handlebar to and fro over the entire steering range.
»
If the cables restrict the freedom of movement of the steering:
–
Correct the cable routing.
100761-01
–
Move the handlebar to the straight-ahead position.
–
Throttle position sensor circuit A - check in the "zero" position. (
Info
It is imperative to use the KTM diagnostics tool for this.
–
Push back protective cover
–
Loosen counter nut
–
Set the play in the throttle cable by turning adjusting screw
100754-10
Guideline
Throttle cable play
–
Tighten counter nut
–
Mount the protective cover.
M8
.
with distance sleeve
.
15 mm (0.59 in)
M5
M8
.
.
3... 5 mm (0.12... 0.2 in)
.
33
20 Nm
(14.8 lbf ft)
5 Nm (3.7 lbf ft)
20 Nm
(14.8 lbf ft)
p. 219)
.