30/ENGINE - WORK ON INDIVIDUAL PARTS
Removing the left main bearing
20.6
Installing the left main bearing
20.7
–
Remove the screws and take off bearing shell bracket
200443-10
–
Mark joint
200444-10
–
Place the engine case section on special tool
Press sleeve (61229045000) (
–
Place special tool
the inside to the outside.
Press drift/press sleeve (61229044000) (
200445-10
–
Select the main bearing shells. (
–
Center the new main bearing shells
Press drift/press sleeve (61229044000) (
200439-10
–
Place the inside of the engine case section on special tool
Press sleeve (61229045000) (
–
Align the face of the new bearing shell with the marking made when it was disas-
sembled.
–
Press the bearing shells with the stepped side of special tool
sleeve
from the outside to the inside, all the way to the stop.
Press drift/press sleeve (61229044000) (
200446-10
of the main bearing shells as shown in the figure.
p. 446)
with the smaller diameter on the bearing shells and press from
p. 140)
using special tool
p. 446)
.
.
p. 446)
.
p. 446)
.
through press
p. 446)
143