Checking The Rear Valve Clearance - KTM 1190 RC8 R EU/UK 2009 Repair Manual

30/ASSEMBLING THE ENGINE

Checking the rear valve clearance

21.44
–
Turn the engine one crankshaft turn in a counterclockwise direction.
Marking
–
Remove screws
–
Mount the new screws
301342-10
–
Turn the engine one crankshaft turn in a counterclockwise direction.
Marking
–
Mount special tool
Engine blocking screw (61229015000) (
–
Remove screws
–
Mount the new screws
301344-10
–
Install the special tool.
Adjustment gauge, control time, cylinder 1 (69129130000) (
–
Mount and tighten screws
Guideline
Screw, special tool
–
Fully tighten screws
Guideline
301464-10
Camshaft drive sprocket bolt
–
Remove screws
–
Remove the special tool.
Adjustment gauge, control time, cylinder 1 (69129130000) (
–
Remove special tool
Engine blocking screw (61229015000) (
–
Turn the engine one crankshaft turn in a counterclockwise direction.
Marking
–
Fully tighten screws
Guideline
Camshaft drive sprocket bolt
301342-10
–
Remove special tool
–
Crank the engine several times.
–
Set the engine to ignition top dead center of the rear cylinder. (
301382-10
faces outward and is flush with the edge of the cylinder head.

.

but do not tighten them yet.

is aligned and flush with the edge of the cylinder head.

.

.

but do not tighten them yet.

.

.

.

.

faces outward and is flush with the edge of the cylinder head.

.

.

p. 444)
p. 447)
M6 3 Nm (2.2 lbf ft)
M6 13 Nm (9.6 lbf ft)
p. 447)
p. 444)
M6 13 Nm (9.6 lbf ft)
p. 123)
185