36/CYLINDER HEAD
Adjusting the rear valve clearance
26.4
–
Remove special tool
–
Crank the engine several times. Check the valve clearance and correct it if neces-
sary.
–
Remove special tool
Guideline
Plug, crankshaft retainer
200540-10
–
Mount and tighten the screw of generator cover
Guideline
Screw in generator cover
200539-10
–
Mount and tighten the spark plug using a special tool.
Spark plug wrench (75029172000) (
–
Position the valve cover seal.
Info
The rear valve cover is equipped with a connector for the engine vent.
The front valve cover is not equipped with a connector for the engine vent.
–
Position the valve cover with the seal. Mount and tighten screws
Guideline
Screw, valve cover
–
Mount the ignition coil.
–
Attach connector
–
Repeat these steps on the second cylinder.
–
Install the filter box bottom. (
–
Install the side covers. (
200538-10
–
Remove the rear camshaft. (
–
Raise cam lever
–
Remove shims
–
Correct and insert the shims as indicated by the results of the valve clearance
check.
–
Install the rear camshaft. (
200546-10
.
and screw in and tighten screw
M8
M24x1.5
p. 448)
M6
of the ignition coil.
p. 68)
p. 75)
p. 205)
on the outside.
and set them down according to the installation position.
p. 205)
.
15 Nm
(11.1 lbf ft)
.
8 Nm (5.9 lbf ft)
.
10 Nm (7.4 lbf ft)
201