30/ASSEMBLING THE ENGINE
Installing the water pump wheel
21.19
Installing the gear position sensor
21.20
Installing the drive wheel of the balancer shaft
21.21
–
Mount the washer and water pump wheel.
–
Mount and tighten screw
Guideline
Screw, water pump wheel
–
Mount dowels
–
Replace the seal.
200398-11
–
Mount the water pump cover.
–
Mount and tighten screws
Guideline
Screw, water pump cover
301394-11
–
Mount the contact springs and contact bolt
The contact bolts are mounted with the flat side forward; the rounded sides
face the sensor.
301399-11
–
Mount gear position sensor
Guideline
Screw, gear sensor
301398-11
–
Heat the drive wheel of the balancer shaft.
Guideline
200 °C (392 °F)
–
Ensure that the spring washer is seated properly. Mount the drive wheel of the bal-
ancer shaft with the beveled edge facing forward.
Pressure bell (61229016000) (
The markings are visible after mounting.
200400-10
.
M6
.
.
M6
with the O-ring. Mount and tighten the screws.
M5
p. 445)
10 Nm
Loctite
®
243™
(7.4 lbf ft)
10 Nm (7.4 lbf ft)
.
3 Nm
Loctite
®
243™
(2.2 lbf ft)
173