Preparing The Engine For Installation; Installing The Engine - KTM 1190 RC8 R EU/UK 2009 Repair Manual

30/ENGINE

Preparing the engine for installation

18.2

Installing the engine

18.3
–
Remove nut
–
Remove the nut of the swingarm pivot. Pull out the swingarm pivot.
–
Take off the swingarm with the shock absorber.
200529-10
–
Have an assistant hold the rear of the motorcycle. Remove the securing belts.
–
Remove screws
Info
Make sure not to misplace the washers.
–
Lower the engine. Raise the rear of the motorcycle. Pull out the engine from the
side.
–
Mount the special tool on the frame.
200530-10
Frame support (61229050000) (
–
Remove both radiator hoses. Remove the vacuum and vent hoses.
–
Position both radiator hoses. Position and tighten the hose clamps.
–
Position the hose fixation. Mount and tighten screw
Guideline
Remaining engine screws
–
Connect the vacuum hoses of manifold absolute pressure sensor
–
Position the vent hoses as shown in the figure.
200531-10
–
Prepare the engine for installation. (
–
Raise the engine onto the special tool and screw it in place.
Floor jack attachment (61229055000) (
–
Remove the special tool.
Frame support (61229050000) (
–
Raise the rear of the motorcycle. Position the engine in the frame.
–
Mount screws
–
Secure the motorcycle against falling over with belts.
200530-11
. Pull out the pin of the bell crank on the frame.

on both sides.

p. 446)
p. 117)
p. 446)
with the washers on both sides but do not tighten them yet.

.

M6 10 Nm (7.4 lbf ft)
.

p. 447)
117