30/ASSEMBLING THE ENGINE
Installing the oil filler tube
21.40
Installing the starter motor
21.41
Checking the rear cylinder control time
21.42
Adjusting the rear cylinder control time
21.43
–
Mount the oil filler tube with the O-ring.
–
Mount and tighten screws
Guideline
Remaining engine screws
301349-10
–
Grease O-ring
Long-life grease (
301384-10
–
Mount and tighten screw
Guideline
Screw, starter motor
301348-11
–
Check the markings of the camshaft.
Info
The markings are shown with the camshafts removed for purposes of illus-
tration.
Align center marking
»
If the markings do not align:
–
Adjust the rear cylinder control time. (
301389-10
–
Remove special tool
Engine blocking screw (61229015000) (
301343-10
.
M6
. Mount the starter motor.
p. 438)
with the ground wire.
M6
of the camshaft with marking
.
10 Nm (7.4 lbf ft)
10 Nm (7.4 lbf ft)
of the camshaft gear.
p. 184)
p. 444)
184