04/SHOCK ABSORBER, SWINGARM
Adjusting the vehicle level at the rear
8.5
Warning
Danger of accidents Modifications to the suspension settings can seriously alter the vehicle's ride behavior.
–
Following modifications, ride slowly at first to get the feel of the new ride behavior.
Removing the shock absorber
8.6
–
Tighten screw
Guideline
Remaining frame bolts
100689-11
–
Loosen screw
100696-10
–
Turn eccentric shaft
Guideline
Standard
Maximum adjustment range between
HIGH - LOW
Open end wrench SW 38 (69012021000)
Info
100697-10
The chassis height can be adjusted in both directions.
–
Tighten screw
Guideline
Screw, clamp, eccentric shaft of
deflector
100698-10
–
Jack up the motorcycle in the middle (insertable type). (
–
Remove the lower screw
200602-10
.
but do not remove it.
to the desired position using the tool from the tool set.
.
of the shock absorber.
M5
5 Nm (3.7 lbf ft)
LOW
180°
M8
18 Nm
(13.3 lbf ft)
p. 12)
46