35/WATER PUMP, COOLING SYSTEM
Filling the cooling system compensating tank
25.6
Warning
Scalding hazard During motorcycle operation, the coolant gets very hot and is under pressure.
–
Do not open the radiator, radiator hoses and other components of the cooling system while the engine is warm. Let the
engine and cooling system cool down first. If you get scalded, immediately flush the affected areas with lukewarm water.
Warning
Danger of poisoning Coolants are poisonous and a health hazard.
–
Avoid contact between coolants and skin, eyes and clothing. If fuel gets into your eyes, rinse immediately with water and
contact a doctor. Wash affected skin areas immediately with soap and water. If coolant is swallowed, contact a doctor
immediately. Change clothes that have come into contact with coolants. Keep coolants out of the reach of children.
Note
Engine damage Impaired cooling efficiency due to air trapped in the cooling system.
–
After draining coolant and refilling the cooling system, the motorcycle must be raised at the front according to the model type.
This is the only way of ensuring that the cooling system is filled without air bubbles.
–
Completely fill the radiator with coolant and close it with radiator cap
–
Position the vehicle on a level surface.
–
Remove the cap of the compensating tank.
–
Add coolant to the compensating tank until the coolant reaches the specified level.
Guideline
The coolant level must be between MIN and MAX.
–
Mount the cap of the compensating tank.
200535-10
–
Check the coolant level. (
–
Remove the cap
–
Top up with coolant until the specified coolant level is reached.
Guideline
The coolant level must be between MIN and MAX.
Alternative 1
Coolant (
Alternative 2
100750-10
Coolant (mixed ready to use) (
–
Mount the cap of the compensating tank.
p. 194)
of the compensating tank.
p. 436)
p. 436)
197
.