KTM 1190 RC8 R EU/UK 2009 Repair Manual page 144

30/ENGINE - WORK ON INDIVIDUAL PARTS
Info
When pressing the bearing in, ensure that the engine case section is level to
prevent damage.
Only press the bearings in via the outer ring; otherwise, the bearings will be
damaged when they are pressed in.
–
After the engine case section has cooled, check that the bearings are firmly seated.
Info
If the bearings are not firmly seated after cooling, it is likely that they will
rotate in the engine case when warm. In this case, the engine case must be
renewed.
–
Mount oil jets
Guideline
Oil jet
–
Mount oil jet
Guideline
Oil jet for clutch lubrication
–
Mount and tighten screw
Guideline
Plug, clutch lubrication
200449-11
–
Press in shaft seal rings
–
Press in the shaft seal ring of push rod
Press drift (61229013000) (
200450-11
–
Mount studs
Guideline
Stud, chain shaft
–
Blow compressed air through all oil holes and check that they are clear.
200442-10
.

M6x0.75
.

.

until they are flush.

.

p. 444)
.

4 Nm Loctite ®
(3 lbf ft)
M6x0.75 4 Nm (3 lbf ft)
M10x1 15 Nm
(11.1 lbf ft)
M6 8 Nm (5.9 lbf ft)
142
243™