08/MASK, FENDER, DECAL
Installing the inside cover
12.4
–
Remove screw
–
Remove the screws of the EFI control unit
unit.
–
Unplug the control unit of the electric starter lock
–
Remove the overflow hose. Take off the right inside cover.
200495-12
–
Position the right inside cover. Mount and tighten screw
–
Position the overflow hose.
–
Plug in EFI control unit
–
Plug in the control unit of the electric starter lock
200495-11
–
Position the left inside cover. Mount and tighten screw
–
Connect the plug-in connectors to generator
–
Screw ground wire
Guideline
Remaining chassis screws
200494-11
–
Mount and tighten screws
200537-11
–
Mount expanding rivets
–
Install the side covers. (
–
Connect the negative (minus) cable of the battery.
–
Fit the seat. (
200493-11
.
and position it. Mount and tighten the screws.
onto the frame.
M6
.
.
p. 75)
p. 70)
. Unplug and remove the EFI control
.
.
.
.
and ignition pulse generator
10 Nm (7.4 lbf ft)
76
.