Removing The Idler And Timing Chain On The Right; Removing The Clutch Facing; Removing The Outer Clutch Hub - KTM 1190 RC8 R EU/UK 2009 Repair Manual
Hide thumbs
Also See for 1190 RC8 R EU/UK 2009:
- Owner's manual (283 pages) ,
- Owner's manual (281 pages) ,
- Owner's manual (242 pages)
Table of Contents
Advertisement
30/DISASSEMBLING THE ENGINE
Removing the idler and timing chain on the right
19.31
Removing the clutch facing
19.32
Removing the outer clutch hub
19.33
–
Take off dowels
–
Remove check valve
200401-10
–
Remove idler
–
Take off the timing chain.
Info
If the timing chain is to be used again, note the direction of travel and the
cylinder on which it was used.
200403-10
–
Loosen screws
together with the spring retainers and the clutch springs.
–
Take off pressure cap
–
Take off push rod
200405-10
–
Remove clutch discs
200406-10
–
Insert special tool
Clutch holder (61229003000) (
–
Loosen nut
–
Remove components
200408-10
. Remove the clutch cover seal.
.
.
of pressure cap
in a crisscross pattern and remove them
.
.
, the support ring and the pretension ring.
into inner clutch hub
p. 443)
and remove it with the washer.
and
of the clutch pressure booster.
and outer clutch hub
.
132
Advertisement
Table of Contents
