30/ASSEMBLING THE ENGINE
Installing the torque limiter and idler
21.26
Installing the ignition pulse generator
21.27
Installing the generator cover
21.28
Installing the oil drain plug
21.29
–
Mount the rear washer, needle bearing, idler
–
Mount torque limiter
200347-11
–
Position the ignition pulse generator
–
Mount and tighten the screws.
Guideline
Screw, pulse generator
–
Position the cable, thinly coat cable support sleeve
and insert it in the engine case.
Loctite
®
5910
200346-10
–
Check the distance between the ignition pulse generator and rotor.
Guideline
Crankshaft position sensor/rotor - gap
–
Mount the new generator cover seal and dowels.
–
Position the generator cover.
–
Mount and tighten screws
Guideline
Remaining engine screws
301392-10
–
Mount the new O-rings.
–
Mount and tighten oil drain plug
Guideline
Oil drain plug
200480-10
and front washer.
with the rear washer.
.
M5
10 Nm
(7.4 lbf ft)
0.70 mm (0.0276 in)
.
M6
with the magnet, O-rings and oil screen.
M20x1.5
176
Loctite
®
243™
with the sealing compound
10 Nm (7.4 lbf ft)
20 Nm
(14.8 lbf ft)