ENGINE CONTROL TROUBLE CODE
Rollover sensor - the signal wire has an open
Condition
The ignition is off.
The EFI control unit is disconnected. (
The break out box is connected to the wiring harness.
The rollover sensor is disconnected. (
Rollover sensor - check the signal wire for opens
–
Measure the resistance between the specified points.
Break Out Box AO pin 4 – Rollover sensor connector AP pin 5
Resistance
»
If the specifications have not been met:
–
Check EFI control unit connector AO (
–
Check the cable from EFI control unit connector AO (
»
If the specifications have been met:
–
Check the next possible cause:
Rollover sensor - the ground wire has an open (
Rollover sensor - the ground wire has an open
Condition
The ignition is off.
The EFI control unit is disconnected. (
The break out box is connected to the wiring harness.
The rollover sensor is disconnected. (
Rollover sensor - check the ground wire for opens
–
Measure the resistance between the specified points.
Break Out Box AO pin 7 – Rollover sensor connector AP pin 4
Resistance
»
If the specifications have not been met:
–
Check EFI control unit connector AO (
–
Check the cable from EFI control unit connector AO (
»
If the specifications have been met:
–
Contact customer service.
p. 227)
p. 226)
600850-11
p. 392) pin 4 and connector AP pin 5.
p. 368)
p. 227)
p. 226)
600850-11
p. 392) pin 7 and connector AP pin 4.
400583-10
≤ 0.6 Ω
p. 392) pin 4 to connector AP pin 5 for opens.
400583-10
≤ 0.6 Ω
p. 392) pin 7 to connector AP pin 4 for opens.
368