36/CYLINDER HEAD
Adjusting the front valve clearance
26.5
Checking the rear cylinder control time
26.6
Checking the front cylinder control time
26.7
–
Remove the front camshafts. (
–
Raise cam lever
–
Remove shims
–
Correct and insert the shims as indicated by the results of the valve clearance
check.
–
Install the front camshafts. (
200552-10
Condition
The valve cover has been removed.
–
Check the markings of the camshaft.
Info
The markings are shown with the camshafts removed for purposes of illus-
tration.
Removal is not necessary.
Align center marking
»
If the markings do not align:
301389-10
–
Adjust the rear cylinder control time. (
Condition
The valve cover has been removed.
–
Remove special tool
Engine blocking screw (61229015000) (
–
Set the engine to the ignition top dead center of the front cylinder and screw in
special tool
301343-10
–
Check the markings of the camshaft.
Info
The markings are shown with the camshafts removed for purposes of illus-
tration.
Removal is not necessary.
Align center marking
»
If the markings do not align:
301389-10
–
Adjust the rear cylinder control time. (
p. 206)
on the outside.
and set them down according to the installation position.
p. 206)
of the camshaft with marking
.
.
of the camshaft with marking
of the camshaft gear.
p. 203)
p. 444)
of the camshaft gear.
p. 203)
202