MOTORCYCLE
Removing the motorcycle from the work stand (screw-in type)
4.4
Note
Danger of damage The parked vehicle can roll away or fall over.
–
Always place the vehicle on a firm and even surface.
–
Screw the holder of the special tool all the way into the lower drill holes of the
footrest brackets. Select the required height and width of the work stand.
Work stand (62529055000) (
–
Jack up the motorcycle.
Info
Check that the work stand is seated correctly.
200600-01
–
Remove the motorcycle from the work stand and rest it on the side stand.
–
Unscrew the holder of the special tool from the drill holes in the footrest brackets.
Remove the work stand.
Work stand (62529055000) (
200600-01
–
Position the footrest bracket. Mount and tighten screws
Guideline
Screw, front footrest
bracket
–
Position the brake fluid reservoir. Mount and tighten screw
Guideline
Screw, brake fluid reser-
voir of rear brake
200599-11
–
Plug in connector
binder
.
p. 447)
p. 447)
M8
M5
of the brake light switch. Secure the cable with cable
.
25 Nm
Loctite
®
243™
(18.4 lbf ft)
.
5 Nm
Loctite
®
243™
(3.7 lbf ft)
11