KTM 1190 RC8 R EU/UK 2009 Repair Manual page 16

MOTORCYCLE
Note
Engine failure High engine speeds in cold engines have a negative effect on the service life of the engine.
–
Always warm up the engine at low engine speeds.
–
Press the emergency OFF switch into the position
–
Switch on the ignition by turning the black programming key to the position ON
After you switch on the ignition, you can hear the fuel pump working for about
two seconds. The function test of the combination instrument is run at the
same time.
–
Shift into neutral.
The green idling speed indicator lamp N
–
Press the electric starter button
Info
Do not press the electric starter button until the function test of the combi-
nation instrument is finished.
When starting the engine, DO NOT apply the throttle. If you apply the throttle
during the starting procedure, the engine management shuts off the injec-
tors and the engine will not start.
Press the starter for a maximum of 5 seconds. Wait for a least 5 seconds
before trying again.
This motorcycle is equipped with a safety start system. You can only start
the engine if the transmission is in neutral or if the clutch is pulled when a
gear is engaged. If the side stand is folded down and you shift into gear and
100677-10
release the clutch, the engine stops.
–
Take the weight off the side stand and swing it upwards with your foot as far as it
will go.
.
lights up.

.
14
.