34/SHIFT MECHANISM
–
The shift rod can be mounted both on the shift lever variably at an upper or lower
position, and on the reverse gear change of the shift shaft in two different posi-
tions.
Guideline
A
0 0 A
Standard
Shift power low, long shift travel
Shift power high, short shift travel
B
0 0 B
–
Position the shift rod.
–
Tighten the screws.
Guideline
Screw, shift rod
0 0 C
C
400479-10
–
The position of the shift lever can be greatly varied, depending on the length of the
shift rod and the drill holes selected. As seen from the footrest, there is either a
high position of the shift lever
Info
If you turn the reverse shift shaft 2 teeth on the serration of the shift shaft,
you can adjust the footrest system optimally for the upper footrest position.
–
After adjusting the shift lever, check its operation. There must be a minimum dis-
tance between the moving parts of the shift lever and other parts of the vehicle.
Guideline
Minimum clearance
100705-10
Shift lever: lower drill hole,
shift shaft: lower drill hole
Shift lever: lower drill hole,
shift shaft: upper drill hole
Shift lever: upper drill hole,
shift shaft: lower drill hole
M6
12 Nm
(8.9 lbf ft)
or a low position of the shift lever
5 mm (0.2 in)
193
Loctite
®
243™
.