14/LIGHT SYSTEM, INSTRUMENTS
Combination instrument - Activation of the BOOTLOADER mode
17.4
Updating the combination instrument software
17.5
–
Press "Continue".
–
Read the information page in the KTM diagnostics tool then using "Continue" pro-
gramm the ICU.
–
Switch off the ignition by turning the black programming key to the position OFF
–
Switch on the ignition by turning the black programming key to the position ON
–
Carry out the start procedure. (
Guideline
The start procedure was successful.
–
Delete trouble code.
–
Switch off the ignition by turning the black programming key to the position OFF
–
Press the button MODEand keep it depressed.
–
Switch on the ignition by turning the black programming key to the position ON
–
Press the button MODEand keep it depressed.
BOOTLOADER mode appears in the combination instrument.
–
Release MODE button.
400661-10
Condition
The ignition is on.
The diagnostic tool is connected and running.
–
Activate the combination instrument - BOOTLOADER mode. (
–
Select the model.
–
Select "DCL".
–
Select "Connect".
In the DCL window, "ECU OK" appears in the right-hand lower part of the
screen.
In the DCL window, "ECU NOT OK" appears in the right-hand lower part of the
screen.
–
Check the connection between XC_1 Scan Box and the diagnostics connec-
tor on the vehicle and repeat the procedure.
400687-60
In the DCL window, "ECU NOT OK" appears in the right-hand lower part of the
screen.
–
Activate the combination instrument - BOOTLOADER mode. (
In the DCL window, "XC_1 Scan Box not found" appears in the right-hand lower
part of the screen.
–
Check KTM diagnostic tool connection to XC_1 Scan Box and repeat the
procedure.
–
Press button
A selection window opens.
–
Select the current file with suffix .kfw and highlight it.
Info
Select the correct file for the vehicle type.
–
Press "Open".
–
Press "Transfer".
The software status is updated.
p. 13)
under "Select flash file".
105
.
.
.
.
p. 105)
p. 105)