01/FORK, TRIPLE CLAMP
–
Position the fender. Mount and tighten screws
Guideline
Remaining chassis screws
201057-11
–
Clean and grease the shaft seal rings
Long-life grease (
100781-11
–
Insert the wide spacer on the left-hand side
travel).
Info
The arrow
–
Insert the narrow spacer on the right-hand side (when viewed in the direction of
travel).
100780-11
Warning
Danger of accidents Reduced braking efficiency due to oil or grease on the
brake discs.
–
Always keep the brake discs free of oil and grease, and clean them with
brake cleaner when necessary.
–
Clean screw
–
Lift the front wheel into the fork, position it, and insert the wheel spindle.
–
Mount and tighten screw
201060-10
Guideline
Bolt, front axle
–
Position the brake calipers and check that the brake linings are seated correctly.
–
Mount screws
–
Operate the hand brake lever repeatedly until the brake lining presses up against
the brake disc and there is a pressure point. Fix the hand brake lever in the acti-
vated position.
The brake calipers align themselves.
–
Tighten screws
Guideline
100719-12
Screw, front brake caliper
–
Release the fixation of the hand brake lever.
–
Release the rear of the vehicle.
–
Remove the motorcycle from the work stand (insertable type). (
and mating surfaces
p. 438)
indicates the direction of rotation of the front wheel.
and the wheel spindle.
.
on both brake calipers but do not tighten yet.
on both brake calipers.
M10x1.25
.
M6
10 Nm (7.4 lbf ft)
of the spacers.
(when looking in the direction of
M25x1.5
45 Nm
(33.2 lbf ft)
45 Nm
Loctite
®
(33.2 lbf ft)
p. 12)
20
243™