KTM 1190 RC8 R EU/UK 2009 Repair Manual page 366

ENGINE CONTROL TROUBLE CODE
Rollover sensor - check if there is an open in the power supply
–
Measure the voltage between the specified points.
Rollover sensor connector AP pin 6 – Measuring point Ground (−)
Voltage
» If the specifications have not been met:
–
Check connector AP pin 6.
–
Check the cable from connector AP pin 6 to the next node in the wiring harness for opens.
» If the specifications have been met:
–
Check the next possible cause:
Rollover sensor - the signal wire has a short circuit to ground (terminal 31) (
Rollover sensor - the signal wire has a short circuit to ground (terminal 31)
Condition
The ignition is off.
The EFI control unit is disconnected. (
The break out box is connected to the wiring harness.
The rollover sensor is disconnected. (
Rollover sensor - check the signal wire for a short circuit to ground (terminal 31)
–
Measure the resistance between the specified points.
Break Out Box AO pin 4 – Measuring point Ground (−)
Resistance
» If the specifications have not been met:
–
Check the cable from EFI control unit connector AO (
ground (terminal 31).
» If the specifications have been met:
–
Check the next possible cause:
Rollover sensor - the signal wire has a short circuit to sensor ground (
Rollover sensor - the signal wire has a short circuit to sensor ground
400583-10
p. 227)
p. 226)
600850-11
Condition
The ignition is off.
The EFI control unit is disconnected. (
The break out box is connected to the wiring harness.
The rollover sensor is disconnected. (
400658-10
4.9... 5.1 V
p. 364)
400658-10
∞ Ω
p. 392) pin 4 to connector AP (
p. 364)
p. 227)
p. 226)
p. 393) pin 5 for a short circuit to
364